Timing belt Movendis P-696-D/8M-180
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Curvilinear Double-Sided Timing Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-696-D/8M-180 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-696-D/8M-180 and any equivalents.
This Movendis belt is a double-sided timing belt in the Curvilinear series, identified by the part number P-696-D/8M-180. The two figures that matter for selection are the profile and the length: 696 mm. Both sides carry teeth, so it drives from either face in a synchronous layout.
When you read the marking on the back of an old belt, match the part number and the 696 mm length before anything else. The curvilinear tooth form seats in the matching pulley grooves, and because this is a double-sided belt, the tooth profile runs on both faces. Confirm the profile against the pulleys on the drive rather than assuming a similar belt will index correctly.
If the drive runs two or more belts, replace them as a set so the load stays even across the pulleys. Inspect the pulleys for worn grooves, debris and misalignment while the belts are off, and check the tensioner travel. A double-sided timing belt is often used where two shafts turn in opposite directions from one drive, so note the routing before removal. Send the part number, the 696 mm length and a photo of the back marking for a quote.
Dimensions
- Length
- 696mm
Frequently asked questions
- What do the profile and length on this belt tell me?
- The profile describes the curvilinear tooth form that must match the pulley grooves, and the length is 696 mm. Both are stated on the Movendis P-696-D/8M-180. Use them together when comparing against the belt you are replacing.
- How do I confirm this is the right belt for my drive?
- Read the part number and length from the back of the belt you are removing and compare them with P-696-D/8M-180 and 696 mm. Check that the tooth profile matches the pulleys and that the belt is double-sided, meaning teeth on both faces.
- What should I send to request a quote?
- Send the part number P-696-D/8M-180, the 696 mm length, the quantity you need, and a photo of the marking on the old belt if you have one. If the number is unreadable, include the drive details and pulley tooth count so we can help confirm the right belt.