Timing belt Movendis P-1015-5M-450
- Brand
- MOVENDIS
- Category
- Power transmission
- Subcategory
- Timing belts
- Series
- Curvilinear H-Type Timing Belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MOVENDIS P-1015-5M-450 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P-1015-5M-450 and any equivalents.
The Movendis P-1015-5M-450 is a curvilinear H-type timing belt in the HTD 5M profile with a 1015 mm length and a 5 mm pitch. If you are replacing a belt on an existing drive, this page gives you the marking and the two dimensions to check before you order.
Matching a timing belt starts with the marking on the back of the old belt. Read it before the belt comes off the drive, since the print can wear or rub away once the belt is handled. The Movendis P-1015-5M-450 carries an HTD 5M profile, a 1015 mm length and a 5 mm pitch, so the replacement has to agree on all three.
Profile and pitch are not the same measurement. The profile describes the tooth form, and the 5 mm pitch is the distance from one tooth center to the next. The 1015 mm length is the belt's own length, not a shaft center distance, so it should be read off the belt marking rather than measured across the pulleys.
When the old marking is gone, send us the part number you have, the profile, the length and the pitch you measured, along with the drive it runs on. We carry Movendis belts and can confirm the right one or suggest an equivalent from what we supply.
Dimensions
- Profile
- HTD 5M
- Pitch
- 5mm
- Length
- 1015mm
Frequently asked questions
- What do I need to match this timing belt to the one being replaced?
- The marking on the back of the old belt is the fastest reference. If it is unreadable, note the profile, the length and the pitch from the drive and send those with the part number you have.
- Is the 1015 mm figure a center distance between pulleys?
- No. It is the belt length. Center distance is a separate measurement taken on the drive and should not be substituted for the belt length when ordering.
- What should I send for a quote?
- Send the part number, or the profile, length and pitch if the number is not readable, by WhatsApp or email. We reply promptly and can help confirm the belt or suggest an equivalent.