V-belt Mitsuboshi C 195
- Brand
- MITSUBOSHI
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
GATES and MITSUBOSHI: matching part numbers →MITSUBOSHI and STARK: matching part numbers →MITSUBOSHI and OPTIBELT: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MITSUBOSHI C 195 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for C 195 and any equivalents.
The Mitsuboshi C 195 is a classical V-belt with a C profile. It measures 22 mm across the top, 14 mm high, and has a 40° angle. Before fitting a new belt, inspect the drive and sheaves for wear that could shorten belt life.
Worn sheave grooves are a common cause of premature belt failure. Check the groove flanks for steps, ridges, or a polished surface, and confirm the sheave runs true without wobble. A belt that sits too deep or too high in a worn groove will slip or overheat even when the replacement is the correct size.
The C 195 is identified by its profile and its length marking. Look for the part number on the back of the old belt and match it to the replacement. The same size is also listed under Stark C 195 and Optibelt C 195, so you can compare markings if the original belt is no longer legible.
When you request a quote, send the part number and the application details. Our team replies promptly by WhatsApp or email and can confirm the right belt or suggest an equivalent. For drives that use multiple belts, replace the full set at the same time and re-tension after the initial run-in.
Dimensions
- Section
- C
Frequently asked questions
- How do I confirm the C 195 is the right size?
- Check the marking on the back of the old belt. The C 195 is a classical V-belt with a C profile, 22 mm top width, 14 mm height, and 40° angle. If the marking is worn, measure the top width and height and send those values with your quote request.
- What should I inspect before installing a new belt?
- Inspect the sheave grooves for wear, steps, or ridges, and check that the sheaves are aligned and run true. Worn grooves can cause a new belt to slip or wear quickly even when the profile and length are correct.
- Can I replace just one belt on a multi-belt drive?
- On drives that use more than one belt, replace all belts as a set so they share the load evenly. Mixing a new belt with used belts can cause the new belt to carry more than its share and fail early. Re-tension the set after the initial run-in.