V-belt Mitsuboshi C 142
- Brand
- MITSUBOSHI
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
GATES and MITSUBOSHI: matching part numbers →MITSUBOSHI and STARK: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MITSUBOSHI C 142 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for C 142 and any equivalents.
The Mitsuboshi C 142 is a classical V-belt with a C profile. This page covers how to match it to the belt you are replacing. The same size is also listed under Stark C 142.
To confirm the C 142 is the correct replacement, read the marking on the back of the old belt. The part number identifies the profile and the length. If the old belt is worn or the marking is gone, measure the top width and height and compare to the profile data: 22 mm top width, 14 mm height, 40° angle. These dimensions are the fastest way to verify the profile before ordering.
A classical V-belt wears along the sides, so a belt that looks intact can still sit too deep in the pulley groove. Inspect the sheaves for wear, oil or debris at the same time. If the drive uses multiple belts, replace the full set so the load stays even across all belts. Mixing a new belt with worn ones can cause the new belt to carry more than its share.
For a quote, send the part number C 142 and the quantity you need. If the marking is unclear, include the top width, height and any length shown on the old belt. We carry Mitsuboshi belts and can help confirm the right profile and length for your drive.
Dimensions
- Section
- C
Frequently asked questions
- How do I match this belt to the one I am replacing?
- Check the marking on the back of the old belt for the C 142 number. If it is unreadable, measure the top width and height and compare to the 22 mm top width and 14 mm height of this C profile belt.
- Can I replace just one belt in a multi-belt drive?
- For drives with multiple belts, replace the full set. A new belt matched with worn belts can run at a different tension and carry more load than the others.
- What should I send to get a quote?
- Send the part number C 142 and the quantity. If the old marking is gone, include the top width, height and any length shown on the belt.