V-belt Mitsuboshi C 110
- Brand
- MITSUBOSHI
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
GATES and MITSUBOSHI: matching part numbers →MITSUBOSHI and STARK: matching part numbers →MITSUBOSHI and OPTIBELT: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
MITSUBOSHI C 110 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for C 110 and any equivalents.
The Mitsuboshi C 110 is a classical V-belt with a C profile, 22 mm top width, 14 mm height, and 40° angle. Before fitting a new belt, inspect the drive and sheaves for wear, misalignment, or damage that can shorten belt life.
Check sheave grooves for wear, cracks, or foreign material. Worn grooves can prevent the belt from seating correctly, leading to slip and premature failure. Verify that shafts are parallel and sheaves are aligned. Misalignment causes uneven sidewall wear and can reduce belt life.
This belt is identified by its C profile and 110-inch length. The same size is also listed under Stark C 110 and Optibelt C 110. When replacing, confirm the part number on the old belt and match it to the new one. If the old belt marking is unreadable, measure the top width and height to confirm the profile.
Proper tension is critical. Too little tension causes slip and heat; too much tension can damage bearings and sheaves. After installation, recheck tension after the first few hours of operation. Keep sheaves clean and free of oil or debris.
Dimensions
- Section
- C
Frequently asked questions
- What should I check on the drive before installing a new C 110 belt?
- Inspect sheaves for wear, cracks, or buildup in the grooves. Check alignment and shaft parallelism. Replace any damaged sheaves before fitting the new belt.
- How do I confirm the C 110 is the right belt for my drive?
- Look for the part number on the back of the old belt. If it is unreadable, measure the top width and height to confirm the C profile, and measure the outside length to match 110 inches.
- Is the same size listed under other brands?
- Yes, the same size is also listed under Stark C 110 and Optibelt C 110.