V-belt Gates SPZ 1347 MN

GATES SPZ 1347 MN belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZ 1347 MN and any equivalents.

The Gates SPZ 1347 MN is a narrow wedge V-belt from the Super HC MN series. It has an SPZ profile, a 1347 mm length, a 9.7 mm top width, an 8 mm height and a 40° angle. When you need to identify a replacement, start by reading the marking on the back of the old belt.

The marking on the back of a belt gives you the profile and length in one line. Look for SPZ and 1347. The profile tells you the cross-section; the length is the datum length in millimeters. Check that the old belt shows SPZ 1347 before you request a quote. If the marking is worn or unreadable, measure the top width and the outside length with a caliper and a tape, and send those numbers along with a photo of the belt.

This Gates belt is a narrow wedge V-belt, also called a narrow V-belt. It is built for drives that use SPZ pulleys. The 9.7 mm top width, 8 mm height and 40° angle match the SPZ profile. When you replace a belt on a multi-belt drive, inspect all the belts in the set. If one belt is worn or stretched, the others are likely at the same point. Replacing the full set helps keep the load even across the grooves.

To request a quote, send the part number SPZ 1347 MN by WhatsApp or email. If you are not sure of the number, send the marking from the back of the old belt, the pulley groove profile, and the width and length you measure. Our team can confirm the right belt for your drive or suggest an equivalent.