V-belt Gates SPZ 1250 MN
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPZ
- Series
- Super HC MN
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES SPZ 1250 MN belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZ 1250 MN and any equivalents.
The Gates SPZ 1250 MN is a narrow wedge V-belt in the Super HC MN series, built for compact, high-capacity industrial drives. It is identified by its SPZ profile and 1250 mm length. Use this page to confirm that the belt on your drive matches these dimensions before requesting a quote.
Narrow wedge V-belts like the SPZ 1250 MN are commonly found on drives where space is tight and power density matters, such as pumps, fans, compressors and other process equipment. The SPZ profile is a narrow cross-section, and the belt has a top width of 9.7 mm, a height of 8 mm and a 40-degree angle. These values, together with the 1250 mm length, are the key figures for confirming fit.
The most reliable way to match a replacement is to read the marking on the back of the old belt. Look for the profile and length, then compare them with the SPZ 1250 MN. If the marking is worn or missing, measure the top width and the outside length, and check the pulley groove angle. A belt that is too wide, too narrow or the wrong length will not seat correctly or will not tension properly.
When you request a quote, send the part number SPZ 1250 MN and, if possible, a photo of the belt marking and the drive nameplate. Our team can confirm the belt or suggest an equivalent based on the profile and length. For drives with multiple belts, it is good practice to inspect all belts and replace them as a set so the load is shared evenly.
Dimensions
- Section
- SPZ
- Length
- 1250mm
Frequently asked questions
- How do I confirm that the Gates SPZ 1250 MN fits my drive?
- Check the marking on the back of the existing belt for the SPZ profile and 1250 mm length. If the marking is not readable, measure the top width (9.7 mm) and the height (8 mm), and verify the pulley groove angle (40 degrees).
- What information should I send with my quote request?
- Send the part number SPZ 1250 MN. If you have it, include a photo of the belt marking and the drive nameplate. This helps us confirm the correct belt or suggest an equivalent.
- Should I replace all belts on a multi-belt drive at the same time?
- Yes. On drives that use more than one belt, replacing them as a set helps maintain even tension and load sharing. Mixing new and worn belts can cause the new belt to carry more than its share of the load.