V-belt Gates SPZ 1140 MN

GATES SPZ 1140 MN belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZ 1140 MN and any equivalents.

The Gates SPZ 1140 MN is a narrow wedge V-belt in the Super HC MN series. Its SPZ profile gives a 9.7 mm top width and 8 mm height, and the belt is 1140 mm long with a 40° angle. Use these figures to confirm the belt fits your drive before you request a quote.

The profile and length are the two numbers that matter most when you are selecting a replacement. SPZ sets the cross-section: 9.7 mm across the top and 8 mm tall, with a 40° angle that seats in the pulley groove. The 1140 mm length is the datum you match against the old belt or the drive specification. If either figure is wrong, the belt will not run correctly, so check both against the marking on the belt you are replacing.

This is a narrow wedge V-belt, often called a wedge belt, and it is used where a compact cross-section is needed for the load. The Super HC MN series is built for industrial drives, and the SPZ profile is one of the standard narrow sections. When you replace a belt on a multi-belt drive, fit a full set of belts from the same series and with the same length so the load is shared evenly.

To request a quote, send the part number Gates SPZ 1140 MN, or the profile and length if the marking is worn. A photo of the belt back and the drive arrangement helps us confirm the right belt. We serve maintenance, engineering and purchasing teams across the United States, Canada, Mexico and South America, and we reply promptly by WhatsApp or email.