V-belt Gates SPB 1400 MN
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPB
- Series
- Super HC MN
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES SPB 1400 MN belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPB 1400 MN and any equivalents.
This Gates SPB 1400 MN is a narrow wedge V-belt in the Super HC MN series. It has an SPB profile, a 1400 mm length, a 16.3 mm top width, a 13 mm height and a 40 degree angle. Before you fit it, inspect the drive and sheaves.
Check the sheave grooves for wear, ridges, or embedded debris. Worn grooves can let a new belt sit too deep, which changes the effective diameter and leads to slip or heat. Confirm that the sheaves are aligned and that the correct SPB profile is called for on the drive.
The belt is marked SPB 1400 MN, which is the easiest reference to match against the old belt. If the marking is worn or missing, measure the outside length and top width, and note the profile and the drive arrangement. Send those details with the part number when you request a quote.
For drives with more than one belt, replace all belts in the set at the same time. A mix of old and new belts can cause uneven tension, vibration, and premature failure. After fitting, recheck tension and alignment after the first run-in period.
Dimensions
- Section
- SPB
- Length
- 1400mm
Frequently asked questions
- What should I check on the drive before installing this belt?
- Inspect sheave grooves for wear, cracks, or debris, and verify alignment. Confirm the sheaves are sized for an SPB profile belt and that the drive is free of oil or excessive heat.
- How do I identify the correct replacement belt?
- Look for the marking on the back of the old belt. If it reads SPB 1400 MN, that is the exact reference. If the marking is unreadable, measure the outside length and top width, and note the profile.
- Can I replace just one belt on a multi-belt drive?
- It is best practice to replace all belts in the set at the same time. Mixing new and used belts can cause uneven load sharing and vibration. Always recheck tension after run-in.