V-belt Gates C 214
- Brand
- GATES
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
- Series
- Hi-Power II
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
GATES C 214 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for C 214 and any equivalents.
The Gates Hi-Power II C 214 is a classical V-belt for heavy-duty industrial drives. It uses a C profile with a 22 mm top width, 14 mm height and 40-degree angle, and a 5486.4 mm length. This belt is typically found on large fans, pumps, compressors and other high-load equipment where a classical C-section belt is specified.
To confirm fit, check the drive for a C-section pulley groove and measure the old belt's outside length. The C 214 is 5486.4 mm long, so the replacement must match that length and profile. Also read the marking on the back of the old belt; if it shows C 214, this belt is the correct size.
When replacing, inspect all sheaves for wear, alignment and debris. A worn groove can cause the belt to sit too deep or slip, which shortens belt life. If the drive uses multiple belts, replace the full set at the same time so the load is shared evenly.
The same size is also listed under Optibelt C 214. Send us the part number, the belt marking or the old belt's dimensions and we will confirm the right belt or suggest an equivalent.
Dimensions
- Section
- C
- Length
- 5486.4mm
Frequently asked questions
- What does the marking on the old belt tell me?
- If the back of the belt reads C 214, this Gates Hi-Power II C 214 matches that profile and length. The C profile has a 22 mm top width, 14 mm height and 40-degree angle.
- How do I confirm the length?
- Measure the old belt's outside length and compare it to 5486.4 mm. The replacement must match both the C profile and this length to fit the drive correctly.
- What should I send for a quote?
- Send the part number C 214, the belt marking or the old belt's profile and length. We will confirm the correct belt or suggest an equivalent.