DODGE P2B-DL-110L pillow block bearing

DODGE P2B-DL-110L belongs to pillow block bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for P2B-DL-110L and any equivalents.

A DODGE DLM pillow block is a mounted unit that pairs a cast iron housing with a ball insert bearing, so it can be bolted down onto a flat surface and used to carry a rotating shaft. Alignment and sealing are handled in the unit itself. MR Industrial Accessories supplies this line and helps buyers match the correct part number to their equipment.

The code can be broken down piece by piece. P stands for pillow block, B for the two-bolt split housing style, DL for the sealing version and L for the way the insert locks to the shaft. The digits in the middle give the shaft size, so P2B-DL-110L is a pillow block with a DLM insert bearing built for a 1.1/2 inch shaft. Because suffixes can change the seal, the outer sleeve or the locking method, it is worth confirming the full number before you ask for a quote.

Typical installations include belt conveyors, bucket elevators, mixers, mills, centrifugal pumps and other process equipment in food, chemical and aggregate operations. The flat-based cast iron housing mounts on steel profiles or concrete beds with two bolts, and the insert bearing absorbs small amounts of misalignment as the shaft turns.

Selection usually starts with the shaft diameter and the direction of the load, which in most conveyors is mainly radial. Then look at sealing: a contact lip seal suits dusty or damp areas, while a labyrinth seal is chosen for higher speeds. When mounting, keep the base flat, tighten the bolts in a cross pattern and confirm the insert is locked to the shaft with its locking system. Relubricate according to the duty cycle and check alignment with a straightedge or dial indicator.

Mounted pillow blocks can often be swapped between brands by shaft number and housing type, but the seal, center height and locking arrangement differ. There is no single cross-reference table, since each manufacturer codes parts its own way. Send the original part number if you have it; if not, give us the shaft dimensions and the distance between the base holes and we will point you to a compatible option in the DODGE line or one that suits your equipment.

To get a quote on a DODGE DLM series pillow block, message us on WhatsApp or by email with the complete part number, such as P2B-DL-110L, or with your shaft and base dimensions. We reply promptly. If you need a sealing or locking variant that is not listed, ask about it as well: we can source it or suggest an equivalent.