DODGE INS-SC-60M insert bearing

DODGE INS-SC-60M belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for INS-SC-60M and any equivalents.

The DODGE SC series is a ball insert bearing built with an extended inner ring and set screw locking, made to sit inside split plummer block housings and wall units. It suits shafts that turn and need support with straightforward alignment, as found on conveyors, mixers and fans. MR Industrial Accessories supplies this line and helps buyers match the insert to their shaft size and housing style.

Reading the insert code is the fastest way to pin down a size. The prefix INS-SC marks an insert in the SC series, the digits that follow give the shaft diameter in millimeters, and the trailing M denotes the sealing and locking version used in this line. So INS-SC-30M fits a 30 mm shaft, and INS-SC-50M fits a 50 mm shaft. Quoting from these codes removes any ambiguity about what you need.

SC series inserts turn up on belt conveyors, bucket elevators, mixers, mills, centrifugal pumps and aggregate processing equipment. Food, chemical and cement plants use them too, since a split plummer block housing lets a crew service or swap the insert without pulling the whole shaft apart. MR Industrial Accessories serves plants that want dependable spares and practical guidance on selection.

Choosing the right insert comes down to three things: shaft diameter, housing type (split plummer block, wall or flange) and the conditions on site, whether that means dust, moisture or frequent washdowns. Locking is done with set screws on the extended inner ring, so the shaft should be clean and free of burrs, and the screws tightened with a proper wrench. Grease from the factory covers most installations; where conditions are harsh, inspect the seal and relubricate on your maintenance schedule.

Interchange between brands follows shaft diameter and mounting configuration rather than the commercial code. A 30 mm SC insert can stand in for another of similar build and dimensions when bore, width and locking method line up. Send the shaft and housing measurements and we will identify the matching option in our catalog.

To request a DODGE SC series insert bearing, message us on WhatsApp with the INS-SC code and the shaft size you need. MR Industrial Accessories replies promptly and can also help you identify an insert from a photo or from the equipment dimensions.