DODGE INS-GTM-307 insert bearing

DODGE INS-GTM-307 belongs to insert bearing, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for INS-GTM-307 and any equivalents.

The DODGE ER-Series insert bearing is a ball bearing with an extended inner ring that mounts into split, pillow block, or flange housings. It suits equipment where the shaft runs on supports that need to be replaced without tearing down the whole machine. MR Industrial Accessories LLC supplies this line from Miami, Florida, to customers across the United States and in several Latin American countries.

Reading the insert code tells you what you have. INS-GTM marks the family, and the digits after it set the bore size and locking style. INS-GTM-012 is a small insert; INS-GTM-100, INS-GTM-103, and INS-GTM-107 cover larger shaft diameters in the same series. Those suffixes do not swap: each one matches a specific shaft diameter and locking system. When you order, give the full code from the housing tag or the old insert.

These inserts show up in belt conveyors, bucket elevators, mixers, mills, packaging lines, and process equipment in food, chemical, cement, and aggregate plants. Housings there deal with dust, moisture, or frequent washdowns. Because the ER-Series mounts in split and pillow block housings, replacement is simpler on lines that cannot stay down long.

Selection comes down to three things: shaft diameter, locking type (set screw, eccentric, or adapter), and sealing. Wet or gritty environments call for higher-containment seals. During mounting, keep the shaft clean and free of burrs, tighten the lock evenly, and check alignment with the housing. Factory lubrication covers start-up; after that, follow your plant's greasing schedule. Poor alignment shortens the life of both insert and housing.

Interchange between brands follows series number and bore dimensions, but locking systems and seals are not always compatible. Before swapping a DODGE for another brand, compare shaft diameter, inner ring width, and the position of the set screws or eccentric ring. We can point you to a compatible alternative and, when the mounting calls for it, quote split housings to measure.

To replace an insert in an existing housing, send the code from the bearing or housing tag by WhatsApp or email. With that, we will quote the equivalent INS-GTM and, if needed, advise on the sealing or locking type for your application. We handle technical inquiries from plants and workshops.