DODGE F4B-SCEZ-010L-SH flange bearing 4 holes

DODGE F4B-SCEZ-010L-SH belongs to flange bearing 4 holes, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for F4B-SCEZ-010L-SH and any equivalents.

This 4-bolt flange bracket is a mounted unit that pairs a cast iron housing with a DODGE SCEZ insert ball bearing. It bolts to a flat surface with four fasteners and holds a rotating shaft perpendicular to that surface. Use it where you need a rigid, easy-to-align support.

The SCEZ code breaks down into useful blocks. The first letters point to the flange bracket family with insert bearing. The numeric section that follows gives the nominal shaft size in inches. In F4B-SCEZ-008L-SH and F4B-SCEZ-010L-SH, the 008 and 010 are shaft sizes. The L stands for the insert locking variant, and SH indicates a particular bracket configuration. Always order from the full model on the nameplate or equipment drawing.

You will find these units on belt conveyors, mixers, blowers, centrifugal pumps, screens and packaging lines. Maintenance teams in food processing, cement, paper, tanneries and general workshops use them as replacements for worn assemblies. The four-bolt flange mounts on sheet metal or structural profiles, with the shaft at a right angle to the mounting plane. Because it is a mounted unit, the bearing and housing come pre-aligned, which saves assembly time.

Selection depends on shaft diameter, load type (radial, axial or combined) and the operating environment. The insert seal determines protection against dust, water or chips; for humid areas or frequent washdowns, choose a tighter seal. The unit ships lubricated, but during service check grease condition and internal clearance. During installation, set the flange on a clean, flat surface, tighten the four bolts in a cross pattern, and confirm the shaft turns freely.

Interchange between brands for flange brackets with insert bearings is based on shaft number, bolt count and locking type, not the full part number. The same shaft diameter can have different center heights and bolt spacing, so verify critical dimensions before replacing. If the original part number has changed, MR Industrial Accessories LLC can identify the compatible alternative.

To replace a DODGE SCEZ series flange bracket, send the part number from the equipment or the shaft and flange dimensions via WhatsApp or email. We will quote it and, when needed, suggest a compatible equivalent. We also manufacture split plummer block housings and custom parts for special cases.