DBH 9562 radial shaft seal — 35 x 48 x 12.5

DBH 9562 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9562 and any equivalents.

The DBH 9562 is a radial shaft seal that keeps oil or grease contained where a rotating shaft passes through a housing. It is found in gearboxes, pumps, electric motors and transmission equipment, where it also blocks dust and water. The code tells you the size: shaft 35 mm, housing 48 mm, height 12.50 mm, with Lx design. Treat it as a wear part and replace it when you see lubricant loss or a loose lip.

This seal carries the code 9562. The three dimensions you need to check before installation are shaft diameter 35 mm, housing diameter 48 mm and height 12.50 mm. The Lx design describes how the lip and metal body are put together. Match those values to your shaft and bore first; if they do not fit, the same DBH line may include an equivalent size.

You will typically find a seal this size on input and output shafts of gearboxes, centrifugal pumps, electric motors, mixers, and belt or chain drives. In each case it runs against a rotating shaft and keeps the lubricant separated from the outside. Agricultural machinery and process equipment exposed to dust or water also use this type of seal. Lip material and spring selection depend on temperature and fluid, so confirm those details against the manufacturer data sheet.

Before mounting, inspect the shaft contact area for burrs or wear and make sure the housing is clean and free of dents. Lubricate the lip, then press the seal in with a mounting tube that contacts the outer edge only, never the lip. A deep groove on the shaft can cause a new seal to fail early. If you are unsure about the installation or the correct design, our team can walk you through it.

To request an equivalent, send the code 9562 or the dimensions 35 x 48 x 12.50 mm by WhatsApp or email. A photo of the old seal and the housing, or the equipment drawing, also helps. With that information we search the DBH line and other alternatives we carry. If Lx is not the right design, we can look at another lip type or material so you receive the correct part.

DBH is one of the seal brands we supply. If the size or design is unclear, message us with code 9562 and we will prepare a quote. We can also assist when the old seal no longer has readable identification.