DBH 9501Pol radial shaft seal — 25 x 35 x 6
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 9501Pol belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9501Pol and any equivalents.
The DBH 9501Pol is a radial shaft seal that fits a 25 mm shaft, a 35 mm housing bore and a 6 mm height. It keeps lubricant in and contaminants out on rotating equipment. MR Industrial Accessories LLC supplies this seal as part of its seals and oil seals range for maintenance and repair work.
The designation 9501Pol identifies this seal. Its three key dimensions are: shaft 25.00 mm (d), housing bore 35.00 mm (D) and height 6.00 mm (h). The Lx-R-H configuration describes a single lip with a spring, intended for lubricated rotating shafts. Replace it with the same designation or with an equivalent that matches those three dimensions.
You will find seals of this size in small gearboxes, electric motors, low-power centrifugal pumps, compressors, and belt- or chain-driven transmission equipment. They also appear in machine tools, mixers and conveyors where oil or grease must be held on a rotating shaft. In every case the seal runs against a machined shaft and a finely finished housing, separating the lubricated side from the outside.
During installation, check the shaft for burrs or wear at the sealing surface, and make sure the housing is clean and free of dents. Apply lubricant to the lip before insertion, then press the seal in with a tube or press that applies force evenly on the body, not on the lip. If the shaft shows a deep groove, a seal with an offset lip may be a better choice. Speed, temperature and lubricant type all affect selection and should be confirmed with the manufacturer.
To find an equivalent, send the code 9501Pol along with the equipment brand and the shaft and housing dimensions. We use that information to search for alternatives in the same seals and oil seals category, keeping the dimensions and lip type unchanged.
For a quote on the DBH 9501Pol seal, contact us on WhatsApp with the code and the quantity you need. If you are unsure about the size, send a photo of the old seal or caliper measurements. We will confirm the correct designation and help you avoid unnecessary changes.
Dimensions
- Shaft (d)
- 25mm
- Housing bore (D)
- 35mm
- Height (h)
- 6.00mm
- Design
- Lx-R-H
Frequently asked questions
- What are the dimensions of the DBH 9501Pol seal?
- The DBH 9501Pol seal has a 25.00 mm shaft diameter, a 35.00 mm housing bore diameter and a 6.00 mm height. These three dimensions define the installation. Check them against your equipment before ordering.
- Does it work for shafts with wear or a groove?
- If the shaft has a pronounced groove where the lip runs, the new seal may not seal correctly. In that case, a seal with the lip in a different position may be needed. Send us the dimensions and a photo of the shaft so we can guide you.
- How do I request the equivalent?
- Write to us on WhatsApp with the code 9501Pol, the equipment brand and the shaft and housing dimensions. We will look for alternatives in seals and oil seals.