DBH 9495/85 radial shaft seal — 24 x 40 x 7

DBH 9495/85 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9495/85 and any equivalents.

The DBH 9495/85 is a radial shaft seal that keeps lubricant in and contaminants out of rotating equipment. It fits a 24 mm shaft, a 40 mm housing bore, and a 7.00 mm width, and it follows the A 100 design: a single lip with a spring. You will find it in gearboxes, pumps, motors, and other power transmission assemblies. MR Industrial Accessories supplies this brand and helps you confirm the right seal for your application.

This seal carries the DBH brand and the code 9495/85. Its dimensions are shaft 24 mm, housing 40 mm, and width 7.00 mm. The A 100 design means a single lip with a spring, which is intended for rotating shafts that run with oil or grease. The lip rides on the shaft while the outer case presses into the housing to hold the seal in place and keep the joint tight. Because it is a wear part, it is normally replaced during scheduled maintenance.

Common locations for this seal include gearboxes, centrifugal pumps, electric motors, compressors, and power transmission equipment. It also appears in machine tools, conveyors, and hydraulic systems where lubricant must stay in and bearings must stay protected. Its compact size makes it a frequent choice for equipment with small-diameter shafts running at moderate speeds. Selection always depends on the operating temperature, shaft speed, and the lubricant in use.

Before installation, check the shaft for burrs or wear and make sure the housing bore is clean and undamaged. Apply the same oil or grease used in the equipment to the lip, then press the seal in squarely. The 7.00 mm width must match the housing depth to avoid leaks. If the shaft shows a worn track, consider a repair sleeve. The right seal for your case depends on peripheral speed, working temperature, and how the elastomer reacts to the lubricant.

If you need an equivalent, send the code 9495/85 or the shaft and housing dimensions. MR Industrial Accessories can look for alternatives in other brands or configurations within the same radial seal category and advise on the most suitable lip design. The exact designation and dimensions are the best reference to avoid errors when replacing a seal.

To request a quote, message us on WhatsApp or email and mention the code. The team replies promptly and can confirm whether this model fits your equipment or suggest other seals and oil seals from the same line.