DBH 9413 radial shaft seal — 45 x 58 x 8

DBH 9413 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 9413 and any equivalents.

The DBH 9413 is a radial shaft seal with an Lx design, meaning a single lip with a spring, intended for rotating shafts. It keeps lubricant in and contaminants out of pumps, motors, gearboxes and similar equipment. The seal is press-fitted into the housing and runs against the shaft. Shaft 45 mm, housing 58 mm, height 8.00 mm.

This oil seal is a wear part. Replace it when you see lubricant leaking or detect play. In service, it protects bearings and gears from dust, water and particles that would otherwise shorten their life.

The DBH 9413 fits a 45 mm shaft, a 58 mm housing and an 8.00 mm height. The Lx design uses a single lip with a spring for lubricated rotating shafts. DBH is a brand MR supplies, and we can suggest equivalents if you send the code or your current dimensions.

Common applications include centrifugal pumps, electric motors, gear reducers, drive shafts and process equipment. These are typically moderate-speed, non-extreme-temperature duties. A failing seal often shows up as a visible leak or as bearing noise from lack of lubrication.

For correct installation, verify the shaft at 45 mm and the housing at 58 mm, with enough depth for the 8.00 mm height. Lubricate the lip before sliding the shaft through. Use a driver that presses on the outer edge, never on the lip. Inspect the shaft contact area for wear or burrs; a deep groove may call for shifting the seal slightly or replacing the shaft. Clean the housing to avoid leaks.

To request a quote for the DBH 9413 or an equivalent, send the code 9413 or your seal dimensions (shaft, housing and height) by WhatsApp or email. The team replies promptly and can advise on lip type, material and spring for your operating conditions, as well as other brands or special configurations.