DBH 8515Vit radial shaft seal — 95 x 118 x 10

DBH 8515Vit belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 8515Vit and any equivalents.

A radial shaft seal of the single-lip type, the DBH 8515Vit keeps oil or grease inside the housing and keeps dust and water out wherever a shaft turns. It sits press-fitted in the bore and rides the shaft on a thin film of lubricant. Like any wear part, it gets replaced once lubricant starts escaping or contamination works its way in. MR Industrial Accessories supplies this brand and helps you match the size to your equipment.

The 8515Vit belongs to the DBH line of radial shaft seals. Its three reference measurements are a 95.00 mm shaft diameter, a 118.00 mm housing diameter and a 10.00 mm height. The Lx-H AH design pairs a sealing lip with a low-profile section, so it suits assemblies where axial room is tight. The elastomer lip presses against the shaft while the outer body holds by interference in the bore. Compound formulation is what the Vit marking refers to, and that formulation sets how the seal behaves under heat and chemical exposure.

Typical locations include gearboxes, centrifugal pumps, electric motors, conveyor rollers, mixers and transmission equipment, in each case a shaft turning inside a lubricated housing. Seals of this type also turn up in dusty areas or where wash water and splashes are present, since they have to hold the lubricant in and limit how much debris gets past. In preventive maintenance the seal matters: a stain under the unit, rising lubricant consumption or wear on the neighboring bearing usually points to it.

When selecting a replacement, confirm that the shaft and bore measurements match the original and that there is room for the 10.00 mm height. The shaft should be free of burrs, with appropriate roughness and a clean sealing track. Apply lubricant to the lip before fitting, keep the seal square to the shaft and press on the outer edge with a tube or a press. A worn shaft may call for a repair sleeve.

For an equivalent or another size, send the code 8515Vit together with the shaft, housing and height measurements, or the drawing of the part. With that information we check the DBH line and the other brands we carry for a compatible option, and we can also guide you on compound choice based on temperature and the fluid involved. Requests are handled over WhatsApp, with a technical reply and no obligation.

MR Industrial Accessories supplies seals, bearings and power transmission components. To request a quote for the DBH 8515Vit oil seal, message us on WhatsApp with the code and dimensions and we will confirm the alternatives.