DBH 8507Vit radial shaft seal — 42 x 60 x 6
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 8507Vit belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 8507Vit and any equivalents.
A lip seal from the DBH line, the 8507Vit keeps lubricant where it belongs and keeps dust, water and particles out of rotating shaft assemblies. Its Lx-R design combines a sealing lip with a spring, so the lip stays in contact with the shaft as it turns. Shaft 42 mm, housing 60 mm, height 6.00 mm. You will find it in pumps, motors, gearboxes and similar industrial equipment.
Reading the size is straightforward: 42 mm is the shaft, 60 mm is the bore it presses into, and 6.00 mm is the overall height. The spring behind the lip holds steady pressure against the shaft, which is what makes the seal work in dynamic service. Oil or grease stays inside the housing, and the bearing behind the seal stays protected.
Gearboxes, centrifugal pumps, electric motors, compressors, fans and power transmission machinery are the usual homes for this seal. In each case the job is the same: hold the lubricant in and block dirt from getting to the bearings. It suits shafts turning at moderate speeds where a dependable barrier against outside contamination is needed.
Before installing, confirm the shaft and housing match the stated dimensions. A shaft free of burrs and heavy wear, with a good surface finish, gives the lip a better chance of lasting. Coat the lip with lubricant, seat the seal square to the shaft and press it in without hitting the lip directly. A damaged housing bore may need repair or a seal with a larger outer diameter.
If you are cross-referencing, send the part number 8507Vit or the dimensions of the seal you are replacing. We can check other brands or series with similar characteristics and tell you whether the mounting space allows a different height or diameter. The goal is a part that fits your equipment.
Send the part number by WhatsApp or email to request a quote. If you are unsure about the application, a photo or the equipment data helps us confirm the model.
Dimensions
- Shaft (d)
- 42mm
- Housing bore (D)
- 60mm
- Height (h)
- 6.00mm
- Design
- Lx-R
Frequently asked questions
- What are the dimensions of the DBH 8507Vit oil seal?
- Shaft 42 mm, housing 60 mm, height 6.00 mm. Verify these before ordering.
- What type of shafts is this oil seal for?
- It is a radial shaft seal for rotating shafts, used where lubricant must be retained and contaminants excluded. It is not intended for static shafts or high pressures.
- How do I request a quote or an equivalent?
- Write to us on WhatsApp or by email with the part number 8507Vit or the dimensions of the seal you need to replace. We send the quote and, if needed, look for a compatible alternative.