DBH 6605 radial shaft seal — 125.41 x 158.78 x 14.28
- Brand
- DBH
- Category
- Seals
- Subcategory
- Radial shaft seals
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DBH 6605 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 6605 and any equivalents.
When a rotating shaft needs its lubricant held in and outside contamination kept out, a radial shaft seal like the DBH 6605 does the job. Its Lz lip-and-spring construction suits large mounting spaces, which is why it turns up in gearboxes, pumps and process equipment. MR Industrial Accessories supplies this brand and helps you match the right seal to your machine.
The 6605 code fixes the size within the DBH line: shaft 125.41 mm, housing 158.78 mm and height 14.28 mm. The Lz designation refers to the lip-and-spring layout, so the sealing edge stays in contact with the shaft. Before you order, confirm these three measurements against the seal you are replacing, since the number alone identifies the size and nothing else.
Seals in this size range are common on gearbox output shafts, process centrifugal pumps, industrial mixers and transmission units where the shaft runs on bearings. In each case the seal separates the oil or grease side from the environment, keeping dust, water and particles away from the bearings and the shaft surface.
Installation calls for the shaft and housing to match the stated diameters. Press the seal in squarely, without hammer blows that could distort the lip, and check that the spring sits in its correct position. A shaft with wear, burrs or a groove should be repaired or fitted with a wear sleeve first. Wipe the bore clean and add a light film of lubricant on the lip to help it seat.
If you need an equivalent, send the 6605 number or the three dimensions of the seal in hand. With that information we can search the DBH line or other brands we carry. We can also advise on the lip design that fits your lubricant and operating conditions.
Quotes are handled by WhatsApp or email at MR Industrial Accessories. Include the part number, or attach a photo of the old seal or caliper readings if you are unsure of the size or design. Our team reviews the request and comes back with the option that suits your equipment.
Dimensions
- Shaft (d)
- 125.41mm
- Housing bore (D)
- 158.78mm
- Height (h)
- 14.28mm
- Design
- Lz
Frequently asked questions
- What size is the DBH 6605 seal?
- It takes a 125.41 mm shaft, a 158.78 mm housing bore and a 14.28 mm height. Check these figures against your old seal before requesting a quote.
- Will the DBH 6605 fit my machine?
- Measure the shaft where the lip runs, the housing bore and the seal width with a caliper. If they read 125.41 mm, 158.78 mm and 14.28 mm, this is the replacement. Otherwise send us your measurements and we will search for an alternative.
- What does the Lz design indicate?
- Lz describes the construction of the radial shaft seal, typically a sealing lip with a spring. Whether it suits your application depends on the lubricant, shaft speed and surrounding conditions, so ask us if you need guidance.