DBH 6292 radial shaft seal — 27 x 62 x 11

DBH 6292 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 6292 and any equivalents.

Part of our seals and oil seals range, the DBH 6292 is a radial shaft seal that sits in the housing and works against the rotating shaft. It keeps lubricant where it belongs and keeps dust, water and particles out. The designation 6292 covers a 27 mm shaft, a 62 mm housing bore and an 11.00 mm height, in the Lz design. Sizes like this turn up often in gearboxes, pumps and power transmission equipment.

Reading the code is the quickest way to check a seal against the one you are replacing. The 6292 designation fixes the three key measurements: shaft 27 mm, housing 62 mm, height 11.00 mm. The Lz design means a single lip with a spring, made for rotating shafts that run with lubrication. Since DBH is one of the brands we supply, each seal arrives with its factory marking and traceability intact.

Wherever two environments have to stay apart, a seal like this does the job: gearboxes, electric motors, centrifugal pumps, mixers, conveyors and machine tools. You will also find it in gear reducers and bearing housings, protecting the bearings from contaminants and holding oil or grease in place. Treat it as a wear part and inspect it at each preventive maintenance stop.

Before fitting, confirm the shaft and housing measurements match the ones above and that the shaft surface is clean, with no burrs or deep scoring. Put lubricant on the lip, then seat the seal with the lip toward the fluid being retained. A worn shaft may call for a seal positioned with the lip in a different spot. Speed, temperature and the lubricant in use all affect the final choice.

Need a replacement? Send the code 6292 or the dimensions 27 x 62 x 11 mm through WhatsApp or email and we will match it within the DBH line or another brand we supply. We can also walk you through design variants, lip materials and special configurations. Confirming the part first is how you avoid buying the wrong seal.

To get a quote, message the code to MR Industrial Accessories. You will get the quote along with the options that suit your equipment. If the size or the installation is unclear, send a photo of the shaft or housing and we will guide you.