DBH 5570Sil radial shaft seal — 110 x 130 x 13

DBH 5570Sil belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5570Sil and any equivalents.

For rotating shafts that need a dependable barrier between lubricant and the outside environment, the DBH 5570Sil radial shaft seal is a lip seal built to fit a 110 mm shaft, a 130 mm housing bore and a 13.00 mm height. Its Lx design combines a sealing lip with a metal outer body. MR Industrial Accessories supplies this brand and can help you confirm that this size and configuration suit your equipment.

The designation 5570Sil identifies this seal, while the dimensions are read as follows: shaft 110 mm, housing 130 mm, height 13.00 mm. In a typical mounting, the seal presses into a machined housing bore and its lip runs against the rotating shaft, holding oil or grease in and keeping dust, water and other particles out. The Lx configuration refers to the lip-and-metal-body construction. If you are checking a replacement, these three measurements are the starting point.

Seals in this size range show up in gearboxes, reducers, centrifugal pumps, electric motors, transmission shafts and process equipment. In each case the seal sits between the lubricated side and the environment, so the operating conditions matter: moderate peripheral speeds and temperatures within the normal range of standard elastomers are the usual working window. Where the fluid, speed or temperature calls for something different, an auxiliary lip or a different lip material may be worth considering.

Installation has a direct effect on how well any radial shaft seal performs. Inspect the shaft for hardness, surface roughness, burrs and scratches before fitting, since the lip can be damaged by any of these. Coat the lip with the same oil or grease used in service, then press the seal in squarely with a suitable tool or press, keeping force even around the outer diameter. Confirm that the 110 x 130 x 13 mm dimensions match both the shaft and the housing bore.

When you need an equivalent, the fastest route is to send the code stamped on the old seal, the designation 5570Sil, or the measurements taken with a caliper. With that information, MR Industrial Accessories can look for an alternative within the same DBH brand or among the other brands we supply, always keeping the shaft, housing and height dimensions consistent. We can also discuss which elastomer and lip design fit your equipment best.

To request a quote, send the code 5570Sil or the dimensions 110 x 130 x 13 mm by WhatsApp or email. Our team replies promptly with the options and the technical details you need to replace the seal correctly. If you are unsure about selection or installation, we can help you work out the right solution for your application.