DBH 5426 radial shaft seal — 32 x 47 x 10

DBH 5426 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5426 and any equivalents.

A radial shaft seal that keeps lubricant where it belongs and keeps dust and water out. The DBH 5426 measures 32 mm at the shaft, 47 mm at the housing and 10 mm in height, and it comes in the Lx design. Maintenance teams order it by code, and MR Industrial Accessories LLC helps confirm the fit before the quote goes out.

The 5426 designation identifies this seal within the DBH line. Reading the size is straightforward: shaft 32.00 mm, housing 47.00 mm, width 10.00 mm. The Lx design is a single lip with a spring, made for rotating shafts that run with lubrication. DBH groups general industrial seals under this nomenclature. If you need the lip material or the tolerances, we check the manufacturer's data before quoting.

You will find this type of seal in gearboxes, centrifugal pumps, electric motors, conveyor rollers and power transmission equipment. Its job is twofold: hold oil or grease in, and block dust, water and particles from getting to the bearings and bushings. Agricultural and road machinery also relies on it, where mud and vibration are part of daily operation. Treat it as a wear part and swap it out at every scheduled teardown.

Installation is where most seal failures start. Inspect the shaft for burrs or wear, make sure the housing is clean and not deformed, then lubricate the lip with the same oil or grease the equipment uses. The Lx design works at moderate speeds and low pressures. If your application runs hotter or at higher pressure, ask about a variant built for that. The three dimensions plus the fluid being retained are what drive the selection.

If 5426 is not the code your machine calls for, we can search for an equivalent in the same oil seal category. Send the shaft, housing and height measurements, or just the number stamped on the old part. With that information we review options from the DBH brand and other lines we supply, keeping your machine's critical dimensions intact.

To get a quote, send the code by WhatsApp or email to MR Industrial Accessories LLC. A photo of the part or caliper readings works too. We reply promptly with the quote and, when useful, with equivalent options to consider.