DBH 5360 radial shaft seal — 47 x 80 x 6.35

DBH 5360 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5360 and any equivalents.

The DBH 5360 is a radial shaft seal that keeps oil or grease contained between a rotating shaft and its housing. Its dimensions are 47 mm shaft diameter, 80 mm housing diameter and 6.35 mm height, with an Lt design. It is commonly found in gearboxes, pumps, electric motors and power transmission equipment. MR Industrial Accessories supplies this brand and helps you select the correct seal for the job.

The seal is identified by the designation 5360. Its size is given as shaft 47 mm, housing 80 mm, width 6.35 mm. The Lt design means a single lip with a spring, which retains lubricant and keeps contaminants out under moderate rotation. The lip elastomer and metal case work together to stay tight on the shaft.

Seals of this size are used in gearboxes, centrifugal pumps, electric motors, rollers and power transmission assemblies. They hold oil inside the unit and block dust, water or particles that would speed up wear on bearings and gears. Because it is a wear part, replace it when you see a leak or excessive axial play.

Before installation, confirm the shaft is 47 mm and the housing is 80 mm, with no burrs or marks that could cut the lip. Coat the lip with the same oil or grease used in service, then press the seal in perpendicular to the shaft using a tube or press that contacts the outer diameter. The 6.35 mm height should sit flush or slightly recessed as the housing requires. Do not strike the lip.

To quote an equivalent, send the code 5360 or the dimensions 47 x 80 x 6.35 mm and describe the application. We check the designation against the manufacturer's data and offer the option that fits best. We can also review design or material variants based on the fluid and operating temperature. The DBH brand is one we supply, with technical support to help you choose the right seal.