DBH 5299 radial shaft seal — 38 x 62 x 10

DBH 5299 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5299 and any equivalents.

A radial shaft seal from DBH, reference 5299, built for a 38 mm shaft, a 62 mm housing bore and a 10 mm width. The Lx design means a single sealing lip with a spring, the usual choice for rotating shafts that run with oil or grease. Its job on the machine is twofold: hold the lubricant inside the housing and keep dust, water and other contaminants out, so bearings and bushings last as intended. MR Industrial Accessories supplies this brand and can help you match the seal to your equipment.

Reading the code is the fastest way to confirm a replacement. The 5299 designation identifies the DBH reference, while the three figures describe the fit: shaft 38 mm, housing 62 mm, width 10 mm. On a drawing or an old part you can check the same values with a caliper. If the numbers line up, the seal drops into the same bore and rides on the same shaft journal. DBH is one of the brands MR supplies, and the part follows that manufacturer's specification for this reference.

You will find this seal in centrifugal pumps, electric motors, gearboxes, compressors, and belt or chain drives. In each case it sits in the cover or housing, sealing the gap where the shaft passes through. It suits equipment running at moderate speeds and normal operating temperatures, where a 38 mm shaft needs dependable retention of oil and reliable exclusion of dust or water.

Installation decides how long the seal lasts. Clean the shaft and the housing bore and remove burrs or sharp edges before anything goes in. Put a light film of the same lubricant used in the equipment on the lip, then press the seal squarely to the bottom of the bore with a tube or driver of the right diameter. Never strike the lip directly, and keep the seal straight as it enters. When you pick a seal, weigh shaft speed, operating temperature, lubricant type and whether abrasive contaminants are present.

For an equivalent, send the code 5299 or the dimensions 38x62x10. Shaft and housing measurements from your equipment also work, and they help when the original marking is worn off. Quotes are handled by WhatsApp or email by part number, and the team can suggest equivalents and assist with selection.

To ask about the DBH 5299 oil seal or another size, send the code by WhatsApp or email. The team replies promptly with the options that fit your application.