DBH 5200Sil radial shaft seal — 60 x 80 x 10

DBH 5200Sil belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5200Sil and any equivalents.

The DBH 5200Sil is a radial shaft lip seal that keeps lubricant inside a housing and keeps dust and moisture out where a shaft turns. It fits gearboxes, pumps, electric motors and comparable assemblies. The Lx design is a single lip with a spring, and its 60 mm shaft, 80 mm housing and 10 mm height suit replacement work where there is little room along the shaft. MR Industrial Accessories supplies this seal through its seals line.

Reading the code and the size string is the quickest way to confirm you have the right part. The designation DBH 5200Sil identifies the seal, and the three figures follow the usual order: shaft 60 mm, housing 80 mm, height 10 mm. The Lx design tells you it is a spring-loaded single lip seal for a rotating shaft. DBH is one of the brands MR supplies, so the part arrives with its own identification and traceability. If the nomenclature on your old seal is unclear, send the part number and we will confirm it.

These seals turn up in gearboxes, centrifugal pumps, electric motors, compressors and transmission equipment, as well as machine tools and process lines that run continuously. In every case the shaft rotates inside a stationary housing, and the lip does two jobs at once: it holds the oil or grease in and blocks contaminants from entering. Because the lip wears against the shaft, the seal is a wear item and is normally replaced once leakage or noise appears.

Installation is straightforward but the details matter. Check that the shaft measures what the designation calls for and that its surface is clean and free of burrs, and make sure the housing bore is sound and not distorted. Put a film of lubricant on the lip before you seat the seal, then drive it in with a press or a proper installation tool rather than striking it directly. Speed, temperature and the lubricant in use all affect seal selection, so tell us those values if they are not listed and we will point you in the right direction.

For an equivalent, the fastest route is to send the complete part number, a photo of the seal and caliper readings from the shaft and housing. With that we can look for alternatives within the same series or in other brands we carry, and we can also review design variants if the Lx configuration does not suit your equipment. The goal is to keep a machine from sitting idle over a sealing component.

To get a quote on the DBH 5200Sil, send the part number to MR Industrial Accessories by WhatsApp or email. We reply promptly with purchasing options, and we can also advise on installation or compatibility if you are unsure. Our team is available to help you select the correct seal the first time.