DBH 5195 radial shaft seal — 50 x 80 x 10

DBH 5195 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 5195 and any equivalents.

When a gearbox, pump or motor starts weeping oil around the shaft, the DBH 5195 seal is the replacement to look for. It is a radial shaft lip seal sized for a 50 mm shaft, an 80 mm housing bore and a 10 mm width, built in the Lx configuration. MR Industrial Accessories supplies this seal as part of its seals and oil seals range for maintenance and purchasing teams across the United States and Latin America.

Reading the number is straightforward: 50 mm is the shaft diameter the lip rides on, 80 mm is the housing bore it presses into, and 10 mm is the overall height. The Lx designation tells you the seal has one lip with a spring, the usual setup for rotating shafts that run with oil or grease. The rubber lip contacts the shaft while the metal outer case holds the seal in the housing. The 5195 code identifies it within the radial shaft seal family.

You will find this seal wherever lubricant has to stay in and contaminants have to stay out. Gearboxes, centrifugal pumps, electric motors, compressors, mixers and conveyors are typical hosts. It also suits equipment exposed to dust or water, where the lip acts as a barrier in front of the bearings and gears. Plant maintenance crews keep it on the shelf for routine seal replacement without reworking the assembly.

Installation rewards a little care. Check that the shaft is clean and free of burrs or scratches, and that the sealing surface has the right roughness. Put a film of lubricant on the lip, then press the seal in square to the shaft, never striking the lip itself. If the housing bore is worn, ask about a seal with a reinforced case before you install. Speed, temperature and the fluid in service all affect selection, so confirm those against the manufacturer's data sheet.

Need a different size or an equivalent? Send the 5195 code along with the shaft, housing and height dimensions, and a photo of the old part if you have one. We will look for alternatives in the DBH line or in the other brands we carry. If the seal sits in an assembly with bearings or bushings, tell us, so the replacement matches the rest of the system.

To get a quote for the DBH 5195, message the code to MR Industrial Accessories on WhatsApp or by email. We reply promptly with the quote and replacement options. Because we also manufacture split plummer block housings, roller chains and sheaves, we can help you line up the seal with the surrounding components.