DBH 1360 radial shaft seal — 41 x 61 x 10/15

DBH 1360 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 1360 and any equivalents.

When a rotating shaft passes through a housing, the DBH 1360 radial shaft seal keeps lubricant where it belongs and keeps dust, water and particles out. Its dimensions are 41 mm at the shaft, 61 mm at the housing bore and a height of 10/15 mm, so it fits equipment such as gearboxes, pumps, electric motors and general industrial machinery. MR Industrial Accessories supplies this brand and helps you confirm the right seal for the job.

The item is a DBH 1360 radial shaft seal. The code 1360 identifies the size, and the dimensions read as follows: shaft diameter (d) 41 mm, housing diameter (D) 61 mm, height (h) 10.00/15.00 mm. Its A 308-R AH design uses a sealing lip with a stepped height, which helps it seat correctly in the housing. Elastomers selected for resistance to oils and greases form the sealing element, while a metal case gives the seal its rigidity. In short, it is a wear part that keeps sealing effective on equipment with rotating movement.

You will find this seal in gearboxes, centrifugal pumps, electric motors, compressors and bearing positions on industrial machinery. It sits in a cover or casing and seals the point where the shaft passes through, which protects both the bearings and the lubricant. Power transmission equipment such as gear reducers and motors is a common home for it, since leaks and contamination are concerns there. The 41x61x10/15 mm size suits a nominal 41 mm shaft in a 61 mm housing bore, with a height that fits grooves from 10 to 15 mm.

Installation starts with clean surfaces: check the shaft and housing for burrs and scratches before fitting. Apply the same oil or grease used in the equipment to the lip, then press the seal in. Because the height is 10/15 mm, it can sit in a cavity with a shoulder; the lip should face the fluid being retained. Selection depends on shaft speed, operating temperature and how the elastomer reacts to the lubricant. If the shaft is worn, consider a seal with an auxiliary lip or a different size.

For an equivalent, message us on WhatsApp. We can search other brands or sizes with minor dimensional differences, provided the sealing conditions still hold. Send the code 1360 or the dimensions 41x61x10/15 mm along with your working conditions: speed, temperature and lubricant type. We can also advise you when the housing has a different shoulder or the shaft diameter is slightly off.

MR Industrial Accessories supplies the DBH brand within its seals and oil seals line. If this seal fits your equipment, send the code 1360 on WhatsApp and we will prepare a quote. You can also send the shaft and housing dimensions, or a photo of the original part, and we will help you identify the correct seal. Selection and installation advice is part of what we do.