DBH 1358 radial shaft seal

DBH 1358 belongs to radial shaft seal, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 1358 and any equivalents.

A radial shaft seal from the DBH line, the 1358 is built to design A 378 and fits a housing measuring 60.5 mm across and 8.00 mm high. Seals like this one hold lubricant in place and keep dust, water and other contaminants out of rotating assemblies, which is what protects the shaft and the bearings around it. Maintenance crews treat it as a routine replacement item, and getting the dimensions and lip material right is what decides how well it seals and how long it lasts. It belongs to the seals and oil seals range we supply.

The code to look for is DBH 1358. The figures that matter when you check it against your equipment are the 60.5 mm housing bore and the 8.00 mm height, both tied to design A 378. Measure the actual assembly before you order, because a seal that looks similar on paper can still be the wrong fit.

You will find seals of this type in gearboxes, pumps, electric motors, rollers and transmission equipment. Depending on the series, the lip may be single or double, and the job is the same either way: keep oil or grease inside and block dust and water from getting in. Speed, temperature and the fluid being sealed determine which lip compound and spring are appropriate. A failed seal leads to leaks and, before long, worn bearings.

Installation matters as much as selection. The housing should be clean, free of burrs and chamfered correctly. Put a little lubricant on the lip, then drive the seal in with a tube that presses on the outer diameter rather than the lip. Keep shaft and housing runout to a minimum so the seal is not damaged on the way in. When replacing an old seal, match the design and dimensions against the original.

If you are cross-referencing the DBH 1358, send the code along with your housing and shaft dimensions. Our team can suggest equivalents and help you confirm the right choice. We also manufacture split plummer block housings, roller chains and sheaves in-house, so technical support is part of the conversation.

The DBH 1358 oil seal is part of our seals line. Send the code and your equipment dimensions by WhatsApp or email and we will get a quote back to you promptly.