V-belt Dayco CP80
- Brand
- DAYCO
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
- Series
- Classical wrapped industrial belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DAYCO CP80 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for CP80 and any equivalents.
The Dayco CP80 is a classical V-belt in the C profile, built for industrial drives that run on standard classical sheaves. It measures 2133.6 mm in length, with a 22 mm top width, 14 mm height and a 40 degree angle. This page covers how to match it against the belt you are replacing.
The most reliable way to match this belt is to read the marking on the back of the old belt and compare it with the part number and profile here. If the marking is worn or unreadable, measure the outside length of the old belt and confirm the cross-section: the CP80 is a C profile belt, 22 mm across the top, 14 mm tall, with a 40 degree angle. Those three dimensions identify the profile; the 2133.6 mm figure identifies the length.
A belt that is close in length but wrong in profile will not sit correctly in the sheave groove, so check the section before ordering. If the drive runs more than one belt, note how many are on it and replace them as a set so the load stays evenly shared. Send the part number, the profile and the length you measured, and the team can confirm the CP80 or point you to an equivalent.
Dimensions
- Section
- C
- Length
- 2133.6mm
Frequently asked questions
- How do I confirm the CP80 is the right belt for my drive?
- Check the marking on the back of the belt you are removing, then compare the profile and length. The CP80 is a C profile classical V-belt, 22 mm top width, 14 mm height, 40 degree angle, 2133.6 mm length. If the old marking is gone, measure the outside length and the cross-section.
- What should I send to request a quote?
- Send the part number CP80, or the belt marking if you have a different number, along with the profile and the length you measured. Photos of the belt and the sheave groove help confirm the section. The team replies by WhatsApp or email.
- Should I replace all the belts on the drive at once?
- On a multi-belt drive, replace the full set together. Belts that have run different hours sit at different tensions and the load will not be shared evenly across the grooves.