V-belt Dayco CP360
- Brand
- DAYCO
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- C
- Series
- Classical wrapped industrial belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DAYCO CP360 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for CP360 and any equivalents.
The Dayco CP360 is a classical V-belt in the C profile, with a length of 9194.8 mm, a top width of 22 mm and a height of 14 mm. The 40 degree angle is the included angle of the belt cross-section. For a buyer, the profile and the length are the two figures that decide whether this belt fits the drive.
Profile sets the cross-section that has to sit correctly in the pulley groove. C profile here means a 22 mm top width and a 14 mm height, with a 40 degree angle. The length of 9194.8 mm is the figure to match against the drive, since a belt that is too short or too long will not tension or run as intended.
The CP360 is a classical wrapped V-belt from the Dayco line we carry. If you are matching an existing belt, read the marking on the back of the old belt and compare the profile letter and the length before ordering. Where the drive runs more than one belt, replacing the full set at the same time keeps the load shared evenly across the grooves.
Send the part number CP360 by WhatsApp or email to request a quote. If you are unsure whether this is the correct belt for your drive, include the profile and length from the old belt, or a photo of the marking, and we can help confirm the right belt.
Dimensions
- Section
- C
- Length
- 9194.8mm
Frequently asked questions
- What do the profile and length of the Dayco CP360 tell me?
- The C profile gives a 22 mm top width, a 14 mm height and a 40 degree angle, so the belt is built to seat in a C section pulley groove. The 9194.8 mm length is the dimension to check against the drive before ordering.
- How do I confirm this is the belt on my drive?
- Read the marking on the back of the old belt. Match the profile letter and the length, and check the cross-section against the pulley groove. If the marking is worn, send us the profile and length you measure and we can help confirm the right belt.
- How do I request a quote for the CP360?
- Send the part number CP360 by WhatsApp or email. If you need more than one belt, include the quantity and we will reply promptly.