V-belt Dayco AP80
- Brand
- DAYCO
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
- Series
- Classical wrapped industrial belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
DAYCO AP80 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AP80 and any equivalents.
The Dayco AP80 is a classical V-belt in the A profile, with a top width of 13 mm, a height of 8 mm, a 40-degree angle and a length of 2082.8 mm. Classical wrapped V-belts like this one are used on traditional industrial drives where a single belt runs in a matched groove. To confirm fit, compare the profile letter and the length shown on the old belt with these figures.
Classical V-belts are common on pumps, fans, compressors and other general drive equipment. The A profile is a widely used cross-section, so the marking on the back of the old belt is the fastest way to identify what the drive takes. Look for the profile letter and the length, then check the belt for cracking, glazing or missing cover before ordering.
The Dayco AP80 measures 2082.8 mm in length, with a 13 mm top width, an 8 mm height and a 40-degree angle. These dimensions describe the belt only; they do not confirm that it fits a specific drive. Confirm the groove profile and the required length on the equipment before replacing.
If you are replacing a set of belts on a multi-belt drive, note the quantity and the condition of the others. Send the part number, the profile and the length to our team by WhatsApp or email, and we can help confirm the right belt or suggest an equivalent.
Dimensions
- Section
- A
- Length
- 2082.8mm
Frequently asked questions
- How do I confirm the Dayco AP80 fits my drive?
- Check the marking on the old belt and compare the profile letter and length with the AP80: A profile and 2082.8 mm. Also measure the pulley groove to confirm it matches the 13 mm top width and 40-degree angle. If the marking is worn, send photos and the drive details for help.
- What should I send to request a quote for this belt?
- Send the part number AP80, the profile A and the length 2082.8 mm by WhatsApp or email. If you are replacing a set, include the quantity. Our team replies promptly and can help confirm the right belt or suggest an equivalent.
- Can I replace just one belt on a multi-belt drive?
- On drives that use several belts, replacing them as a set helps keep tension even. If only one belt is damaged, inspect the others for wear and send the full quantity so we can help you match the set.