V-belt Dayco AP148

DAYCO AP148 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for AP148 and any equivalents.

The Dayco AP148 is a classical wrapped V-belt in an A profile, with a 3810 mm length, 13 mm top width, 8 mm height, and a 40-degree angle. It is built for industrial drives where a standard A-section belt is specified. Before you fit it, inspect the drive and sheaves so the new belt is not damaged by worn components.

Check sheave grooves for wear, rust, and buildup. A groove that has worn wide lets the belt sit too deep, so it slips and runs hot. Verify that the sheaves are aligned and that the shafts turn freely. If the old belt failed early, look for a seized bearing or a misaligned drive before installing the Dayco AP148.

Measure the old belt and confirm the profile and length. The AP148 is an A-profile classical V-belt, 3810 mm long, with a 13 mm top width and 8 mm height. The 40-degree angle is the standard V-belt angle. If the drive uses multiple belts, replace them as a set so the load is shared evenly.

To request a quote, send the part number AP148 and the quantity you need. If you are unsure about the profile or length, include the marking on the back of the old belt and a photo of the drive. The team can confirm the A-profile belt or suggest an equivalent.

For maintenance and purchasing teams, the AP148 is a direct replacement for an A-section classical V-belt of the same length. Keep the old belt as a reference until the new one is running correctly.