V-belt Dayco 3VX 600

DAYCO 3VX 600 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 3VX 600 and any equivalents.

The Dayco 3VX 600 is a cogged narrow V-belt in the 3VX profile with a length of 1524 mm. If you are replacing a worn belt, start by confirming these two values against the belt on the drive. The same size is also listed under Mitsuboshi 3VX 600 and Stark 3VX 600.

To match the belt being replaced, read the marking on the back of the old belt. Look for the profile (3VX) and the length designation (600), which corresponds to 1524 mm. If the marking is worn away, measure the outside length and the top width, then compare them to the 3VX profile and 1524 mm length of this Dayco belt. A belt that is too long or too short will not tension correctly, and the wrong profile will not sit properly in the pulley grooves.

The cogged construction of this narrow V-belt is suited to drives where a standard wrapped belt may run hotter or slip. Because it is a 3VX profile, it is narrower than a classic V-belt and is used on industrial drives that call for a narrow wedge belt. When you replace a belt, inspect the pulleys for wear, oil, or debris, and check that the sheave grooves are not worn beyond their original shape. If one belt in a set is worn, replace the full set so the load is shared evenly.

If you are unsure whether this is the correct belt for your drive, send a photo of the old belt marking or the drive nameplate. We can help confirm the profile and length or suggest an equivalent. The same size is also listed under Mitsuboshi 3VX 600 and Stark 3VX 600, which may help if you are cross-referencing a belt already on the shelf.