TIMKEN Y1S-362A tapered roller bearing de doble hilera

TIMKEN Y1S-362A belongs to tapered roller bearing de doble hilera, part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for Y1S-362A and any equivalents.

TIMKEN 2TS-DM double row tapered roller bearings are matched assemblies that carry radial and axial loads in both directions from a single mounting position. Each unit runs two rows of tapered rollers on a shared axis, which makes it a fit for gearboxes, drive shafts and transmission equipment. MR Industrial Accessories supplies this TIMKEN line to maintenance and purchasing teams across the United States and Latin America.

Reading the code helps you order the right assembly. Take Y1S-362A, Y1S-382A and Y4S-592A: the first block names the assembly, the second the cone or cup it pairs with. The Y plus its number marks the assembly variant, the S covers sealing or internal configuration, and the A suffix flags a revision. The 2TS-DM family covers double row mountings built either with two cones and a common cup or with two matched cups.

These assemblies show up in gearboxes, axles and differentials, road machinery shafts, mining equipment, mills and conveyors. Rolling mill rolls and agricultural machinery also use them where the shaft sees combined load and there is no room for two separate bearings. Because they come matched, installation is simpler and equipment setup time drops.

Selection comes down to sealing, internal clearance and lubrication method. A sealed unit holds grease in and keeps contaminants out; an open one needs grease circulation or an oil bath. Set axial clearance during mounting and avoid over-tightening, since excess preload raises temperature and shortens service life. Housing-to-shaft alignment matters, and raceways should be clean before you close the assembly.

Tapered roller bearings are identified by cone and cup codes, and each brand numbers the same mounting its own way. Match equivalents by dimensions and contact angle, not by code alone. When the assembly is factory matched, replace it as a complete unit rather than mixing components from different sources. MR Industrial Accessories can point you to the compatible alternative.

Send the code engraved on the bearing, the equipment drawing number or a photo of the part by WhatsApp or email. With that information we quote the TIMKEN assembly and advise on mounting. We handle technical inquiries from workshops, plants and maintenance teams.