TIMKEN SNT 508-607 split plummer block housing

TIMKEN SNT 508-607 belongs to split plummer block housing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SNT 508-607 and any equivalents.

Timken SNT series split bearing housings are made in two halves, so a bearing can be installed or replaced while the shaft and drive stay in place. Maintenance crews choose them for rotating shafts that are hard to reach or costly to tear down. MR Industrial Accessories LLC supplies this line to customers across the United States and in several Latin American countries, and can help you match the housing to the bearing you plan to run.

The SNT code groups sizes into families: SNT 200/300, SNT 500/600 and SNT 3000/3100. The digits after SNT are a size reference, not a measurement, so they have to be checked against the manufacturer's table to see which bearing fits. When you request a quote, include the full code and the bearing you intend to mount.

Typical applications include conveyors, pumps, fans, mixers and process lines where the shaft carries radial load with some axial load. In food, cement, mining and aggregate operations, the split cap speeds up replacement: open the top half, swap the bearing, close it again, and the shaft stays where it is. These housings also work well on older machines whose original housing is no longer sold as a complete unit.

Selection comes down to three things: shaft diameter, the bearing to be housed, and the sealing the site calls for. SNT housings take different seals, such as labyrinth, radial shaft seal or grease, depending on contamination and speed. During mounting, both halves must sit on a flat surface, the shaft must be aligned, and the bolts must be tightened evenly. Grease goes in through the channel in the cap, and clearance should be checked after the first hours of running.

Split housings of this type can often be cross-referenced between brands by series number and bearing size, but no universal equivalence exists because each maker publishes its own table. If the old housing has no readable brand, the shaft size and the bearing inside it are enough to identify it. MR Industrial Accessories LLC can handle that cross-reference when you send those details.

If you already know the housing code or the bearing that goes in it, send it by WhatsApp or email and the team will reply promptly with a quote. If you need a variant that is not listed, share the model or the dimensions and we will help you locate the Timken SNT series housing that fits your equipment.