TIMKEN S95 split plummer block housing

TIMKEN S95 belongs to split plummer block housing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for S95 and any equivalents.

Timken Series S split housings are cast iron units that open into two halves, allowing split cylindrical roller bearings to be installed without removing the shaft or disassembling the drive. These housings are built for continuous process equipment where downtime is costly—conveyors, mills, pumps, fans, and gearboxes. MR Industrial Accessories LLC supplies them across the United States, Canada, Mexico, and South America, with technical support to help you select the right size.

The Series S code consists of a letter followed by a sequential number, and each code identifies a specific size within this family. The number alone does not indicate shaft diameter or housing width; rather, each code corresponds to a particular combination of housing, cap, and associated bearing. When requesting a quote, provide the full code shown on the equipment or nameplate. The series includes MEDIUM SERIES SUPPORT and HEAVY SERIES SUPPORT, offering two levels of robustness for different load conditions.

In industrial settings, these housings are found on clinker and mineral conveyors, cement mills, high-flow centrifugal pumps, induced draft fans, and belt gearboxes. They also appear in aggregate processing and oilseed operations. The split design simplifies maintenance: remove the top cap, replace the bearing, and close the unit again—without disturbing the shaft. This reduces downtime and avoids major shaft work.

Selection starts with the split bearing to be housed and the shaft diameter. Then choose MEDIUM or HEAVY series based on radial load and operating conditions. During assembly, verify alignment of the two halves and proper tightening of the joining bolts; a poorly seated gasket can allow contaminants to enter. Lubricate with consistent grease, renewed according to the duty cycle. If the equipment runs with vibration, inspect the housing fit on its base.

Split housings from different manufacturers can be interchanged by part number and bearing size, not by series letter. Timken, SKF, FAG, and NSK each use their own nomenclature for the same function. If you have an original code from another brand, send it to us—we can identify a compatible alternative. The letter does not need to match; what matters is the housing geometry and the bearing it accepts.

To request a quote for your Timken Series S housing, contact us via WhatsApp or email with the full code and, if possible, a photo of the nameplate or assembled unit. We will respond promptly. If your housing code is not listed, send the model or bearing size anyway—we will work with it and provide the option you need.