TIMKEN MSM160A split bearing

TIMKEN MSM160A belongs to split bearing, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for MSM160A and any equivalents.

For maintenance teams that need to replace a bearing without pulling the shaft or the drive, the Timken MSM160A split housing is a mounted split cylindrical roller bearing unit. It fits equipment where space is tight and every hour of downtime matters, such as conveyors, mills, pumps and large fans. MR Industrial Accessories supplies this line and can help you match the right configuration to your shaft and application.

The MSM prefix marks the Timken series of mounted split housings. The digits that follow give the shaft size in millimeters: MSM160A is built for a 160 mm shaft. The trailing A identifies the construction variant. If you are unsure which variant your equipment carries, send the full part number by WhatsApp or email and we will confirm the matching reference.

These housings are common in cement, mining, steel, paper, sugar and aggregate processing, where large shafts run under high loads and continuous cycles. Typical installations include clinker conveyors, ball mills, high-flow centrifugal pumps and industrial fans. Because the housing splits, the bearing can be changed without removing the shaft or the transmission, which shortens scheduled maintenance windows.

Selection comes down to shaft diameter, load type (radial, axial or combined) and the surrounding environment. The MSM series can be grease or oil lubricated depending on the housing design, so check the sealing needed against dust, water or temperature. At mounting, tighten the joining bolts to the specified torque and verify shaft-to-housing alignment to avoid parasitic stresses that shorten bearing life.

Split housings from different brands can often be swapped when shaft dimensions, center height and fixing type line up. Timken, SKF, NSK and others offer comparable lines, but tolerances and sealing systems differ. Before substituting one housing for another, compare the mounting drawings and let our technical team validate compatibility.

When you need a split housing, message us with the part number or the model on the equipment. MR Industrial Accessories will quote the Timken reference or a compatible alternative with the same mounting dimensions. We also manufacture split plummer block housings to order for special configurations.