TIMKEN LO212 housing seal

TIMKEN LO212 belongs to housing seal, part of our Bearing housings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for LO212 and any equivalents.

The Timken LO series seal is a component that fits into 500/600 series split plummer block housings, which are also called SNT or FSNT. It keeps lubricant in and keeps dust, water and particles out, so the bearing is protected and lasts longer in tough conditions. MR Industrial Accessories supplies this line.

The code starts with LO and then three digits. That number tells you which housing size it fits: for instance, LO211 goes with a 500/600 series housing for a 55 mm shaft bearing, while other codes cover other shaft sizes. Letters added at the end may show the lip material or the seal design, but always check that the seal matches your housing and bearing before asking for a quote.

These seals go into equipment that uses split plummer block housings and runs where there is dirt, moisture or frequent washdown. You will find them in conveyors, elevators, mixers, mills and pumps in food, cement, mining, steel and agriculture. MR Industrial Accessories supplies them to production plants, maintenance workshops and machinery builders that need dependable spare parts.

To pick the right seal, look at the housing code and the shaft diameter. The seal has to fit the housing groove, and the lip must sit on the shaft or sleeve without being distorted. When you install it, make sure the surfaces are clean and free of burrs, put the same grease on the lip as you use in the bearing, and check that the seal sits correctly in both the lower and upper halves of the housing. Good alignment stops leaks and early wear.

Timken LO series seals can be used in place of seals from other brands for equivalent split plummer block housings, as long as the housing dimensions and shaft diameter are the same. When you request a quote, give us the full seal code and, if you can, the housing or bearing code too. MR Industrial Accessories can suggest a compatible alternative or make a special part if your size is not standard.

If you need seals for your split plummer block housings, send a WhatsApp message with the code LO211, LO212 or the one that matches your equipment. At MR Industrial Accessories we quote quickly and point you to a compatible alternative if needed. We can also manufacture special parts from your sample or drawing.