V-belt Stark SPZ 1437
- Brand
- STARK
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- SPZ
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
GATES and STARK: matching part numbers →MITSUBOSHI and STARK: matching part numbers →OPTIBELT and STARK: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
STARK SPZ 1437 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for SPZ 1437 and any equivalents.
The Stark SPZ 1437 is a narrow wedge V-belt with an SPZ profile and a length of 1437 mm. This page covers how to match it to the belt you are replacing. The same size is also listed under Mitsuboshi SPZ 1437 and Optibelt SPZ 1437.
Start by reading the marking on the back of the belt you are replacing. Confirm the profile reads SPZ and the length reads 1437. Then check the dimensions against this belt: 9.7 mm top width, 8 mm height and a 40° angle. A narrow wedge V-belt is identified by profile and length, so these are the values to compare before ordering.
If the old belt is worn, cut or unmarked, measure it across the top and across the height, and measure the length along the belt. Match those measurements to the SPZ profile and the 1437 mm length. If the belt runs in a multi-belt drive, replace the full set so every belt in the drive carries the same load.
Send the part number, the profile and the length by WhatsApp or email to request a quote. Our team replies promptly and can help confirm the right belt or suggest an equivalent. Photos of the back marking and the drive help us verify the match.
Dimensions
- Section
- SPZ
Frequently asked questions
- How do I confirm the Stark SPZ 1437 is the right belt?
- Check the marking on the back of the belt: it should read SPZ and 1437. Then compare the dimensions: 9.7 mm top width, 8 mm height and 40° angle. If those match, this is the correct profile and length.
- What should I send to request a quote for this belt?
- Send the part number SPZ 1437, the profile and the length. If you are replacing an unmarked belt, include the measured top width, height and length, plus a photo of the drive if possible.
- Is this belt listed under other brands?
- Yes. The same size is also listed under Mitsuboshi SPZ 1437 and Optibelt SPZ 1437.