V-belt Stark B 93
- Brand
- STARK
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- B
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
GATES and STARK: matching part numbers →OPTIBELT and STARK: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
STARK B 93 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for B 93 and any equivalents.
This is a Stark B 93 classical V-belt in a B profile. It measures 17 mm across the top, 11 mm in height and carries a 40° angle. Use it where a classical B-section belt is called for and confirm the fit against the drive before ordering.
Classical V-belts in the B section turn up on general industrial drives: fans, pumps, compressors, conveyors and similar equipment where a single belt or a matched set runs between two sheaves. The 17 mm top width and 11 mm height place it in the B cross-section, so it seats in a B-profile groove rather than an A or C groove.
To confirm fit, read the marking on the back of the old belt and compare the profile and the length designation to this one. Check the sheave groove for wear, look for glazing, cracking or fraying on the belt, and verify alignment and tension. Where a drive runs more than one belt, replace the set together so the load stays even across the grooves.
The same size is also listed under Optibelt B 93. Send us the part number, the quantity and the drive details by WhatsApp or email and we will confirm the right belt or suggest an equivalent.
Dimensions
- Section
- B
Frequently asked questions
- How do I confirm this B 93 belt fits my drive?
- Check the marking on the back of the belt you are replacing and compare the profile and length designation. Also confirm the sheave groove is a B section, since this belt is 17 mm top width and 11 mm height with a 40° angle.
- Can I replace just one belt on a multi-belt drive?
- On drives that run a set of belts, replacing the full set keeps tension and load sharing even across the grooves. Mixing a new belt with worn ones can leave the new belt carrying more than its share.
- What should I send for a quote?
- Send the part number B 93, the quantity you need and the equipment or drive it goes on. If you are unsure of the size, send the marking from the old belt and we will help confirm it.