V-belt Stark A 64
- Brand
- STARK
- Category
- Power transmission
- Subcategory
- V-belts
- Section
- A
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Other brands for this category
Ask us for alternatives. We check every equivalent against the part number and your application.
DODGE and STARK: matching part numbers →GATES and STARK: matching part numbers →MITSUBOSHI and STARK: matching part numbers →OPTIBELT and STARK: matching part numbers →
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
STARK A 64 belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for A 64 and any equivalents.
The Stark A 64 is a classical V-belt with an A profile. This page covers how to match it to the belt you are replacing so the drive goes back together correctly.
Start with the marking on the old belt. A classical V-belt is identified by its profile and its length, so confirm the replacement carries the same A profile and the same length as the belt that came off the drive. The Stark A 64 has a 13 mm top width, an 8 mm height and a 40° angle. Compare those dimensions against the belt in hand rather than against a general description of the drive.
If the old marking is worn or unreadable, measure the belt and check the pulley groove. The profile must sit correctly in the sheave, and the 40° angle is what lets the belt wedge into the groove and transmit load. Inspect the sheaves at the same time for wear, and replace belts in sets where the drive runs more than one belt so the load stays evenly shared.
The same size is also listed under Mitsuboshi A 64 and Optibelt A 64. Send us the part number, the profile and the length you read off the belt, and we will confirm the Stark A 64 or point you to the equivalent.
Dimensions
- Section
- A
Frequently asked questions
- How do I confirm the Stark A 64 is the right belt for my drive?
- Read the marking on the belt being replaced. If it shows an A profile and the same length, the Stark A 64 is the matching size. If the marking is gone, measure the top width and height and check that the profile seats properly in the pulley groove.
- What do I need to send for a quote?
- Send the part number, the profile and the length from the old belt, along with the drive it runs on. If you have the old belt in hand, the marking on the back is usually enough for us to confirm the size.
- Is the same size listed under other brands?
- Yes. The same size is also listed under Mitsuboshi A 64 and Optibelt A 64.