Timing belt Stark 1778-14M-10
- Brand
- STARK
- Category
- Power transmission
- Subcategory
- Timing belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
STARK 1778-14M-10 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for 1778-14M-10 and any equivalents.
This Stark 1778-14M-10 timing belt is a synchronous belt with an HTD 14M profile and a 14 mm pitch. It is used in industrial drives where timing and synchronization are critical, such as on conveyors, packaging equipment, and other machinery that relies on precise motion transfer.
To confirm fit, check that your drive uses an HTD 14M pulley and that the belt's length and width match your current belt. The 1778-14M-10 marking on the back of the belt identifies its profile, pitch, and width. If you are unsure, send a photo of the old belt's marking or provide the drive's part number.
When replacing a timing belt, inspect the pulleys for wear, alignment, and proper tension. A worn pulley can quickly damage a new belt. If the drive uses multiple belts, replace them as a set to maintain even load distribution and avoid mismatched wear.
Dimensions
- Profile
- HTD 14M
- Pitch
- 14mm
Frequently asked questions
- What does the 1778-14M-10 marking mean?
- The marking indicates the belt's profile, pitch, and width. For this belt, the profile is HTD 14M and the pitch is 14 mm. The full part number is 1778-14M-10.
- How do I confirm this belt fits my drive?
- Check that your pulleys are HTD 14M and that the belt length and width match your current belt. You can also send us the drive's part number or a photo of the old belt's marking for verification.
- Can I replace just one belt in a multi-belt drive?
- It is best to replace all belts in the drive at the same time. Mixing new and worn belts can cause uneven tension and premature failure.