SKF Z 010 sealing washers
- Brand
- SKF
- Category
- Seals
- Subcategory
- Sealing washers
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
SKF Z 010 belongs to sealing washers, part of our Seals range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for Z 010 and any equivalents.
SKF Z series sealing washers are axial seals used in rotating equipment to hold lubricant in and keep contaminants out. They appear in gearboxes, pumps, electric motors and transmission assemblies, protecting bearings and wear surfaces. MR Industrial Accessories LLC supplies this line and can help you match the washer to your housing and shaft.
The Z designation is a letter plus a three-digit number that points to a standardized size table. Small sizes include Z 007, Z 008 and Z 009; mid-range sizes include Z 010, Z 013 and Z 200; the largest in the series are Z 204 and Z 205. The number is not the diameter itself, so always confirm the part number against the housing and shaft dimensions before ordering.
These washers are found in food, chemical, petrochemical and metallurgical plants, on centrifugal pumps, gear reducers, fans and conveyors. Their job is to stop dust, water or process fluids from reaching the bearings, which helps extend assembly life and reduce unplanned downtime.
Selection depends on three measurements: shaft diameter, housing outside diameter and the width of the space available. The washer should sit flat and undistorted. In dirty or humid areas, check the elastomer type and the sealing lip. Lubricate the lip before installation and avoid impacts that could nick the edge. Good shaft-to-housing alignment improves sealing and limits premature wear.
SKF Z series sealing washers can be replaced with equivalents from other brands when the standardized dimensions and elastomer material match. A similar part number is not enough; compare the dimension table and the application conditions. MR Industrial Accessories LLC can help you find the right equivalent if you send the dimensions or the original part number.
To request a quote for SKF Z series sealing washers, send the part number or dimensions by WhatsApp or email. The team replies promptly and can suggest equivalents or help you choose the correct size.
Dimensions
Dimensions and tolerances: Message us the part number on WhatsApp and we'll verify its dimensions and version with the manufacturer's datasheet.
Frequently asked questions
- How do I identify the size of an SKF Z series sealing washer?
- The three-digit number refers to a standardized dimension table, not the direct diameter. Compare the part number with the shaft and housing dimensions, or send us the equipment data.
- What is the difference between a Z washer and a conventional oil seal?
- A Z washer is a thin-profile axial seal for tight spaces. A conventional oil seal usually has a radial lip and a spring. The choice depends on the movement type and the space in the assembly.
- Are SKF Z series washers interchangeable with other brands?
- They can be interchanged with equivalent products from other brands if the standardized dimensions and material match. Do not rely only on the part number; check the dimension table and service conditions.