SKF YET 210-115 CW y-bearing (insert bearing)

SKF YET 210-115 CW belongs to y-bearing (insert bearing), part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for YET 210-115 CW and any equivalents.

The SKF YET CW Y-bearing is an insert with an extended inner ring and set screw locking, made to be installed in split plummer block or flanged housings. It suits rotating shaft equipment that needs a straightforward, sturdy bearing unit that is easy to mount. The design tolerates minor misalignment and handles combined loads in general industrial use.

Reading the designation YET ... CW: YET is the SKF insert series with extended inner ring and set screws. The following number gives the shaft diameter, either in inches or millimeters depending on the suffix. For instance, YET 205-100 CW fits a 1 inch shaft, while YET 208 CW fits a 40 mm shaft. The CW suffix means a stamped steel cage and a particular insert design. Part numbers with a hyphen and three digits (like YET 206-102 CW) indicate inch dimensions; those with only two digits (like YET 210-115 CW) can combine a metric diameter with other variants. Always verify the full part number to get the right size.

These inserts appear in many industries: food processing, textile, material handling, agricultural and machine tools. They are common in conveyors, fans, mixers, pumps and transmission equipment. Their capacity to support moderate radial and axial loads makes them suitable for continuously rotating shafts. As part of the Y-bearing category, they mount in housings that allow initial alignment and simplify maintenance. MR Industrial Accessories supplies this SKF line for replacement and new projects.

When selecting the correct insert, consider shaft diameter, load type and environmental conditions. The YET CW series includes a contact seal to retain lubricant and keep contaminants out. Internal clearance is standard and needs no extra adjustment. During mounting, ensure the shaft is clean and free of burrs, and tighten the set screws with a suitable wrench. Aligning the housings is key to avoid parasitic loads. For equipment with vibrations, consider additional fastening.

For equivalences, SKF YET CW inserts can be interchanged with Y-bearings from other brands that share dimensions and locking type. However, not all suffixes match: always check outside diameter, width and sealing system dimensions. Interchangeability between brands is possible if tolerances and housing design are respected. For replacements, compare technical specifications and consult a specialist. MR Industrial Accessories can advise you on the right equivalence.

To request a quote for an SKF YET CW Y-bearing, send the complete part number via WhatsApp. At MR Industrial Accessories we reply with the technical information so you can proceed with your project or maintenance.