SKF RIS 207 A y-bearing (insert bearing)

SKF RIS 207 A belongs to y-bearing (insert bearing), part of our Bearings range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for RIS 207 A and any equivalents.

The SKF RIS A series Y-bearing is an insert bearing that features an extended inner ring and uses set screws to lock onto the shaft. It is designed for equipment where mounting must be straightforward and the bearing arrives sealed and pre-lubricated. Typical uses include agricultural machinery, conveyors and general industrial equipment. MR Industrial Accessories supplies this line and can help you select the right variant for your application.

The code RIS A breaks down as follows: RIS indicates the Y-bearing series with extended inner ring and set screw locking; the number that follows (for example, RIS 206 A or RIS 207 A) corresponds to the bearing size based on shaft diameter; and the A suffix denotes a design variant within the series. When ordering a replacement, provide the complete part number from the tag or the old bearing.

These bearings are found in seeders, harvesters, conveyor belts, mixers, fans and process equipment. In food processing, agriculture and material handling, their quick mounting and effective sealing help reduce downtime. They are also used in older machines that require compatible replacements without modifying the housing.

For proper selection, check the shaft diameter and housing type. Choose the seal according to the environment: contact seals for dusty or wet conditions, non-contact seals for high speeds. Set screw locking demands a clean, burr-free shaft; apply the recommended torque and verify alignment with the housing. The bearing is lubricated at the factory, but during service it is wise to inspect the seals and relubricate if the equipment has a grease fitting.

Y-bearings from different manufacturers share standardized dimensions, but suffixes and locking systems can differ. Do not substitute by part number alone without confirming diameter, width and seal type. If you are unsure, send a photo or the original part number and we will compare it with the RIS A series. MR Industrial Accessories can guide you through the process.

To request a quote, message us on WhatsApp with the complete part number (e.g., RIS 206 A or RIS 207 A) and the quantity required. If you cannot locate the reference, send the shaft and housing measurements. We will then confirm the suitable variant and advise on mounting.