SKF PHG VS37X10X900 timing belt
- Brand
- SKF
- Category
- Power transmission
- Subcategory
- Timing belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
SKF PHG VS37X10X900 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PHG VS37X10X900 and any equivalents.
A timing belt from the SKF PHG VS line does the job of a gear drive while keeping the elasticity of a belt: it drives synchronized shafts without slipping, which matters whenever rotational accuracy has to be held. MR Industrial Accessories supplies this line as part of its power transmission range.
Reading the code is the first step. Take PHG VS32X10X820: the three figures that follow the dash give pitch, width and length in that order, so this belt runs a 32 mm pitch, is 10 mm wide and measures 820 mm long. PHG VS identifies a trapezoidal-tooth timing belt family, and the VS suffix points to a construction variant usually chosen for abrasive or otherwise demanding service. Confirm all three figures against the pulleys before you order, since they govern fit.
These belts show up where conveying, dosing or cutting motions must stay in step: food, textile, plastics and wood plants, plus machine tools, industrial printers and packaging lines. The toothed profile meshes with matching pulleys, so the drive holds its ratio instead of slipping the way flat or V-belts can, including at moderate speeds.
Selection comes down to pitch and width matching the pulleys and the power being transmitted, with length set by the center distance and the number of teeth in mesh. At installation, check pulley alignment and tension: slack lets the belt jump teeth, while over-tensioning accelerates bearing wear. Keep pulleys in good condition and free of oil or chips. The belt itself is not lubricated, but the bearings and shafts around it still need attention.
Belts from other makers that carry the same pitch, width and length can often be used in place of an SKF PHG VS belt, though the exact profile and load capacity should be checked, as material or reinforcement differences affect performance and not every series swaps cleanly. To replace one, send the full code to MR by WhatsApp or email; with pitch, width and length in hand, the team can quote the right option and advise on selection and installation.
Dimensions
Dimensions and tolerances: Message us the part number on WhatsApp and we'll verify its dimensions and version with the manufacturer's datasheet.
Frequently asked questions
- How do I read the numbers on a PHG VS belt?
- They stand for pitch, width and length in sequence. PHG VS32X10X820, for instance, is a 32 mm pitch belt, 10 mm wide, 820 mm long. Check those three values before asking for a quote.
- Will a PHG VS belt fit my pulley?
- Compare the belt pitch and width with the pulley. Matching values mean correct meshing, and length follows from the center distance. MR can help if anything is unclear.
- When should a timing belt be replaced?
- No fixed interval applies; load, speed and maintenance all play a part. Look for wear, cracks or damaged teeth, and replace the belt once tension can no longer be held.