SKF PHG PT/C1 010 timing belt
- Brand
- SKF
- Category
- Power transmission
- Subcategory
- Timing belts
We reply promptly.
Tell us the quantity you need and request a quote by WhatsApp or email.
Can't find the exact model? Tell us the part number or model you need. We'll track it down and quote it, whether or not it appears in our catalog.
Description
SKF PHG PT/C1 010 belongs to timing belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PHG PT/C1 010 and any equivalents.
When a drive has to keep the exact ratio between two pulleys, a toothed belt is often the answer. The SKF PHG PT/C line covers this need with belts that engage matching pulleys and transmit motion without slipping. MR Industrial Accessories supplies this line as part of its power transmission range and can help you match the right belt to your equipment.
Reading the code is the first step. PHG identifies the high-performance timing belt family, PT/C tells you the profile and construction, and the trailing number gives the pitch length, as in PHG PT/C1 005 or PHG PT/C1 010. The value follows the manufacturer's standard and may be expressed in millimeters or tenths of an inch. Longer numbers in the series let you span different center distances while keeping the same pitch.
These belts suit drives where position must stay repeatable: machine tools, packaging machinery, industrial printers, precision conveyors and multi-axis systems. Because there is no slip, the relative position of the pulleys is maintained and errors do not accumulate in dosing, cutting or positioning.
Selection comes down to four data points: pitch, tooth profile, width and pitch length. During installation, align the pulleys and set tension as specified; loose tension lets teeth jump, while excessive tension loads bearings and shafts. These belts run dry, so no lubrication is needed. Keep them clear of oil, grease and solvents that attack the compound, and fit guards where dust or chips are present.
Belts from different brands can be used interchangeably when pitch, profile, width and pitch length are the same. A similar code is not enough. Compare the standardized designation, measure the old belt if needed, or check the equipment manual. SKF is one of the brands MR supplies, and its PHG PT/C line follows the same equivalence logic by pitch and profile.
If you know the code of the belt you are replacing, send it to MR Industrial Accessories by WhatsApp or email, along with pitch and width if available. The team will confirm the equivalent within the SKF PHG PT/C line and help you choose the option for your drive.
Dimensions
Dimensions and tolerances: Message us the part number on WhatsApp and we'll verify its dimensions and version with the manufacturer's datasheet.
Frequently asked questions
- How do I identify the pitch and profile of an SKF PHG PT/C timing belt?
- The designation carries the information: PHG is the family, PT/C the profile and construction, and the numeric block the pitch length. Check it against the old belt or the equipment manual. If anything is unclear, send the full code via WhatsApp and we will help you read it.
- Can they be replaced by belts from other brands?
- Yes, when pitch, profile, width and pitch length match. Interchangeability depends on those standardized dimensions, not on the commercial code. With the original code, a suitable alternative can be identified.
- What care does a timing belt need in service?
- Keep the pulleys aligned, check tension to specification and prevent contact with oils, greases or solvents that degrade the compound. Inspect for tooth wear and cracks. No lubrication is required. Correct installation helps avoid premature failure.