SKF PHG AX83.5EP v-belt

SKF PHG AX83.5EP belongs to v-belt, part of our Power transmission range. Tell us how many you need by WhatsApp or email and we'll get back to you promptly with a quote for PHG AX83.5EP and any equivalents.

The SKF AX section classic cogged V-belt is a power transmission belt that runs on grooved pulleys to connect a motor and a driven machine. Its V profile and molded cogs provide grip for torque transmission and help dissipate heat during continuous operation. It suits equipment where mounting space is limited and stable running is required. MR Industrial Accessories supplies this belt and assists with sizing and selection.

The product line uses a designation that begins with PHG, identifying the classic cogged V-belt category. Next is the AX section, which sets the profile width and height within the classic series. A number follows, indicating the outside length in inches. Examples include PHG AX20.25EP and PHG AX22.5EP. The EP suffix denotes a compound and construction variant within the same category. This complete code allows you to identify the belt without ambiguity.

AX section belts are common in machine tools, small compressors, centrifugal pumps, low-power fans, and factory equipment. They also appear in agricultural machinery such as seeders and sprayers, and in food plants with low-power motors and small-diameter pulleys. The cogged construction helps them perform on small pulleys and maintain speed when mounting space is tight.

Selection depends on motor power, rotation speed, and pulley diameter. The AX section requires pulleys with a compatible groove; a worn groove causes slippage and heat. Check pulley alignment with a straightedge or laser, as a few degrees of misalignment shortens service life. Adjust tension according to the equipment manual: too loose it slips, too tight it loads the bearings. Inspect the belt periodically and replace it if you find cuts or wear.

When replacing, compare the complete designation. The AX section may appear under similar nomenclatures from other brands, but belts of the same length are not always interchangeable because compound, cogging, and dimensional tolerance vary. If the original equipment used an SKF belt, the safest choice is the same reference. If you cannot find it, send us the old code and pulley measurements, and we will help you find an equivalent.

To request a quote, send the complete code from the belt, such as PHG AX23.5EP, or the designation in the equipment manual via WhatsApp or email. You can also send a photo of the old belt and pulley measurements. With that information, we will provide a quote. We serve customers across the United States and in several Latin American countries.